This Eraser/Replacer Tool is ordinarily very small.Use the Eraser/Replacer Tool with black set as the primary color (left) and white as the secondary color (right) and Color Replace all the black in the picture with white by holding down the RIGHT MOUSE BUTTON as you work the Eraser/Replacer over the picture and tracing.Now, you will need to replace all of the Black in the picture with White, so pay close attention to details from this point on.If you cannot complete the tracing and the following removal of your pattern or picture before saving, then use SAVE AS in the 24 bit Bitmap type of file formatting before storing the project until it can be finished another day.Ĭhanging your red lines.to a black line drawing.Use the Curve Line Tool, the Line Tool, the various Shape Tools, the Pencil Tool and the Eraser Tool to trace the image.I usually choose a bright green or bright red. Choose a color not in the picture for Color 1.Click outside the drawing board to turn the Selection box off.Use the Moving Arrows to recenter the tree image.Use the 2-way Stretching Arrow to adjust the size of the image by pulling at the corners, the sides or the top and bottom.While the image is still Selected, use the 4-way Moving Arrow to drag the image to the center of the drawing board.Paste the tree image from the Clipboard.Open a new MS Paint drawing, landscape oriented, that is 7.5 inches X 10 inches wide.Use the Snipping Tool to Copy the tree image into the Clipboard.Start the video and let it run for a bit, pausing the video when the drawing of the bare tree shape has been completed.In today's example, open the Draw a Tree and Flowers with MS Paint.Not exactly like working with layers in Photoshop, but it’s a useful workaround. This allows you to lay down and remove “layers” individually. When using the tool this way, it will only erase the selected color. Normally with the Eraser tool, you would click and drag across the image to erase. Then, choose the Eraser tool from the tool tab. Now go back and choose the color of a “layer” you would like to remove once you’re done with it. You can limit paint to interacting with only one color.įor example, you can limit the eraser tool to only work on the red line. Just make sure to choose a different color every time.īy using a different color, you’ve created a “layer” of sorts. Make the next pass over your sketch in this new color. Next, choose a different color for your brush. Note: I am not a sketch artist so this is what you get for the example! Step 2: Create a New “Layer”

You can change the color of your brush by clicking on the color squares in the tool panel at the top of the workspace. Lay down your initial sketch in any color except black.

How to remove layer in ms paint